Dodge Ram 1500 Front Differential Removal. 1.) jack up front end, put jack stand under frane of the side you will be removing. Now the last step is to take out four bolts that hold the shaft.
Use bungy cord to hold to frame in place so it doesnt fall later. To remove the spindle, you have to remove the brake caliper first the remove the ball joint nuts. The bar i'm using is about 18 inches.
The gears in the front pumkin on a 95 1500 ram 4x4 i.bearing. Then remove bolts from shock and upper control arm and hub nut to do this. 3.55 ratio fit my 1996 dodge 1500 4x4.that has a 3.54 ratio on the front axle without any modifications to where it bolts on to the springs or sho.
But not sure if it's even working properly since the housing is still mounted on the differential shaft. Tow package 220k miles, no lift. I need step by step instrution on how to remove and repair or diagnosis the gears in the front pumkin on a 95 1500 ram 4x4 i replaced the bearing on the pass.
Use bungy cord to hold to frame in place so it doesnt fall later. One dealership told me it is dangerous and needs to be fixed. I read that it can be popped out with a pry bar but its not budging for me.
Remove front axle from differential on 2003 dodge ram. Place a drain pan underneath front diff cover and remove cover and drain axle. It took a 20lbs sledge and a good bit of muscle to separate the cv from the inner stub shaft.
I have never hear of these getting replaced together short of a collision. I had to buy new snap rings and a new inner shaft because of spline wear. Remove cover.take off back wheels and calipers (or drums).turn differential to where you see small bolt/pin (5/16) horizontally (same direction as axles)on right side of differential.remove bolt/pin.a large pin (about 5long 3/4diameter) should slide out differential with ease ( you may have to tap one side of the large pin).turn differential to completely remove large pin.turn.